How to Use Eyelashes WT-16 for Doll Customization
By Dollfie — VOLKS USA, INC. | Published: 2026-10-24
Category: How-to Guides
Learn how to apply Dollfie Eyelashes WT-16 to customize your doll's eyes. Step-by-step guide with tips on glue, tweezers, and placement.
Quick answer
Apply Dollfie Eyelashes WT-16 using a plastic-safe glue and bent tweezers for precise placement. Trim the strip to fit your doll's eye shape before gluing.
Choosing the right glue and tools
Not all glues are safe for doll plastics. Use a glue labeled safe for plastics to avoid damaging the doll's face or eye socket. A common mistake is using superglue, which can fog or craze the surface.
Bent tweezers give you better control when handling tiny eyelash strips. The curve lets you press the lash gently into place without smudging the glue or disturbing nearby eye putty.
Trimming and shaping the lashes
Eyelashes WT-16 come as a full strip that may be longer than your doll's eye. Hold the strip against the eye to gauge length, then trim from the outer edge. Cutting from the inner corner can change the natural taper.
If your doll has a narrow eye shape, you can also trim the lash width slightly. Leave a tiny gap at the inner corner for a more natural look.
Step-by-step application guide
- Prepare the eye area: Ensure the doll's eye socket is clean and free of dust or old glue. If the eye is set with putty, let it cure fully before attaching lashes. Working on a clean surface prevents the lash from lifting later.
- Trim the lash strip: Hold Eyelashes WT-16 against the doll's eye and mark the length. Trim from the outer edge with small scissors. Cut slightly shorter than the eye for a natural look. It's easier to trim more later than to fix a too-short lash.
- Apply a thin line of plastic-safe glue: Squeeze a tiny bead of glue along the lash band. Wait 10–15 seconds for the glue to become tacky before placing it on the doll's eyelid. Too much glue can seep into the eye socket or create a visible ridge.
- Position with bent tweezers: Hold the lash with bent tweezers near the center of the band. Lower it onto the eyelid line, starting from the outer corner. Press gently along the band to secure. If the lash shifts, lift it immediately with tweezers before the glue sets.
- Let the glue cure fully: Leave the doll face-up for at least 30 minutes so the glue dries completely. Avoid touching or adjusting the lashes during this time. Rushing the cure can cause the lash to peel off when you pose the doll.
Product details
- Eyelashes WT-16: You can use any common glue to apply these eyelashes to your doll, just make sure that it is safe to use on plastics. This means you don't need a special doll glue, but you must verify the glue is plastic-safe to avoid damaging your doll's face.
Eyelashes WT-16 - Eyelashes WT-16: Bent tweezers can help you grab the tiny hairs and with the curve you can gently press them into place. Using bent tweezers gives you better control and precision, reducing the risk of misplacing the lash or getting glue on the doll's eye.
